Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Cantilever Design in MEMS module
Posted 5 ott 2009, 09:14 GMT-4 0 Replies
Please login with a confirmed email address before reporting spam
I have been trying to design the cantilever beam in 3D MEMS module,
but always come an error crops up i.e:
"No convergence achieved.."
Is there a problem with the amount of force I apply at the edge or mesh resolution or something else?
**Also, How do I vary the thickness and observe the respective change in displacement for the same load??
Can somebody help me, by giving a detailed stepwise procedure to design a simple 3D cantilever beam or give a link to a ppt or pdf which will be useful to me..
Thanks.
Hello ADITYA MATHAD
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.