Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

to create hole in a thin film

Posted 3 mar 2016, 00:44 GMT-5 RF & Microwave Engineering Version 4.4 2 Replies

Kalpana Singh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am facing problem to make holes in a thin film. I made a thin film using 'block' in geometry. Now I need to create holes of rectangular shapes in this film.

Thanks
Kal
2 Replies Last Post 5 mar 2016, 02:13 GMT-5
Suresh Seetharam
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 3 mar 2016, 07:49 GMT-5
Hi,


Make a 2D geometry with rectangular holes and then extrude (you can find this in work plane) that to required depth of the film.


Suresh
Hi, Make a 2D geometry with rectangular holes and then extrude (you can find this in work plane) that to required depth of the film. Suresh
Kalpana Singh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 5 mar 2016, 02:13 GMT-5

Hi

I have made a hole in a silver metal film. Holes are periodic in the metal film. I have applied floquet bounday conditions. but I don't know what's the problem , I have tried all kind of meshing as well but still the simulation shows error.



Hi,


Make a 2D geometry with rectangular holes and then extrude (you can find this in work plane) that to required depth of the film.


Suresh





[QUOTE] Hi I have made a hole in a silver metal film. Holes are periodic in the metal film. I have applied floquet bounday conditions. but I don't know what's the problem , I have tried all kind of meshing as well but still the simulation shows error. Hi, Make a 2D geometry with rectangular holes and then extrude (you can find this in work plane) that to required depth of the film. Suresh [/QUOTE]

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content