Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

stop condition error: stop condition fulfilled for initial values

Posted 18 mar 2016, 06:01 GMT-4 Battery Design, Studies & Solvers Version 5.2 0 Replies

Heather Nute
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to build a model of a 2D li-air battery based on the 1D li-air batt tutorial. I have made it most of the way through the model until I compute, and the error appears:

stop condition fulfilled for initial values.


I have checked all the initial conditions which as correct as for the 1D model, as I understand it the stop condition stops the sweep when the electric potential drops from the initial 2.95V to 2.5V, what the error suggests is that the electric potential is 2.5V or less to start with...

Can anyone see how this has happened? I have only been using comsol for a week or so, so would appreciate the help.
thanks
0 Replies Last Post 18 mar 2016, 06:01 GMT-4
COMSOL Moderator

Hello Heather Nute

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content