Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Gas mixture flow simulation

Please login with a confirmed email address before reporting spam


Hi everybody,

Gas 1 is flowing in my geometry (a round pipe) and I want to inject gas 2 into the flow.

My idea was to assign both gases to the same geometry (using pipe flow module twice) and then use the transport of concentrated species module to adjust the molar fraction of gases in a way to tell COMSOL that initially there was just gas 1 and then an x molar fraction of gas 2 is injected into the flow.

My question is: Is this a right way to deal with the problem and how to tell COMSOL to assign different materials (gas 1 or gas 2) to the same domain dependent on the physics?

Thanks.

0 Replies Last Post 23 mag 2016, 01:38 GMT-4
COMSOL Moderator

Hello Zahreddine Hafsi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.