Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

hai friends

Please login with a confirmed email address before reporting spam

Can anyone help me for designing a lid driven cavity flow in 2D or 3D in comsol? Since am new to this field, i couldnt able to compute in solving the problem because of errotic message showing linear iterations failed to converge.

1 Reply Last Post 29 giu 2016, 08:52 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 29 giu 2016, 08:52 GMT-4
Hello Sudha,
A common mistake made with interior flow problems is to forget to set a gauge pressure somewhere. Without one, the problem is not well-posed (no unique pressure distribution). So apply a pressure point constraint in one corner of your geometry and see if that's the only problem with your set-up.
Best regards,
Jeff
Hello Sudha, A common mistake made with interior flow problems is to forget to set a gauge pressure somewhere. Without one, the problem is not well-posed (no unique pressure distribution). So apply a pressure point constraint in one corner of your geometry and see if that's the only problem with your set-up. Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.