Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
ERT-Electrical Resistivity Tomography
Posted 6 lug 2016, 17:58 GMT-4 Low-Frequency Electromagnetics, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
I recently began using COMSOL and I have some questions. I created a simple ground model (3D), with resistivity 200 ohm*m and a small parallelepiped in its center with resistivity 10 ohm*m. I created a polygon of 25 points (on surface) that represents my electrodes: the electric current is injected through 2 of them. I used AC/DC module, electric currents interface. I want calculate the potential distribution.
How can I set an ERT? How can I automatically move the electrodic configuration?
I hope someone can suggest me how to continue.
Thank You very much!!!
Dora
I recently began using COMSOL and I have some questions. I created a simple ground model (3D), with resistivity 200 ohm*m and a small parallelepiped in its center with resistivity 10 ohm*m. I created a polygon of 25 points (on surface) that represents my electrodes: the electric current is injected through 2 of them. I used AC/DC module, electric currents interface. I want calculate the potential distribution.
How can I set an ERT? How can I automatically move the electrodic configuration?
I hope someone can suggest me how to continue.
Thank You very much!!!
Dora
1 Reply Last Post 7 lug 2016, 10:10 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hello Dora,
This tutorial may be helpful:
www.comsol.com/model/electric-impedance-sensor-7704
Best,
Jeff
This tutorial may be helpful:
www.comsol.com/model/electric-impedance-sensor-7704
Best,
Jeff