Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Error while solving
Posted 23 gen 2011, 05:57 GMT-5 MEMS & Nanotechnology, MEMS & Piezoelectric Devices 4 Replies
Please login with a confirmed email address before reporting spam
I am getting the following error while solving a 2D axi-symmetric model of electrowetting. I had defined the material epsilon. Used both triangular and quadrilateral meshing. Getting the same error both the times.
Failed to evaluate variable Jacobian.
- Variable: mat.epsilonr11
- Geometry: 1
- Domain: 1
Kindly help..
Please login with a confirmed email address before reporting spam
That appears typically when you have forgotten to define all parameters of the materials used, check your materials, note that when you change some physics parameters often you need other material proparties, and sometimes these are not all defined
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
I had read the same in one earlier post and checked if I had defined the material properties.
I also tried defining the relative permittivity of the materials as global variables too...
still the same error message is displayed while solving...
if you have any idea please help.
With regards
Rahul
Please login with a confirmed email address before reporting spam
which version are you running ? since I have got the 4.1 patched I cannot remember any of those
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam