Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Changing the default equation in level set model

Posted 14 gen 2017, 05:30 GMT-5 Fluid & Heat, Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers Version 5.2a 1 Reply

Sumedh Mool
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I was exploring Level-set method for 2 phase laminar flow and wondering if I can change the default equations according to my wish. If yes, how can I change the equation in pressure boundary condition

[-pI + µ(∆u+(∆u)T]n = -(pˆo)n
(pˆo)<=po

to

µ(d2v/dx2+ d2v/dy2+ d2v/dz2)=0

Thank you
1 Reply Last Post 14 gen 2017, 05:32 GMT-5
Sumedh Mool
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 14 gen 2017, 05:32 GMT-5
Please check the screen shot for better representation of the equation.
Please check the screen shot for better representation of the equation.

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content