Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing for turbulent flow

Posted 28 gen 2011, 01:06 GMT-5 Fluid & Heat, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD), Mesh Version 4.1 1 Reply

Ali Masabai
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

My model is turbulent flow in 3-D pipe and this pipe subject to heat flux at upper surface of the pipe. So there are

solid and fluid domains. My question is, what is the best mesh for this case
1 Reply Last Post 28 gen 2011, 01:37 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 28 gen 2011, 01:37 GMT-5
Hi

in 4.1 and CFD I always let COMSOL propose a mesh first (based on the physics). Then I analyse it and decide to change or not, and often I let it go as is at least for a first analysis. If it solves fully or partly, I have the indications of the gradients and the cell Reaynolds number, that helps to decide what to do with the mesh for the final run.

V4.1 is now really good for quite complex CFD, but I must state I do not have any comparison of "real complex CFD" as done with other tools

--
Good luck
Ivar
Hi in 4.1 and CFD I always let COMSOL propose a mesh first (based on the physics). Then I analyse it and decide to change or not, and often I let it go as is at least for a first analysis. If it solves fully or partly, I have the indications of the gradients and the cell Reaynolds number, that helps to decide what to do with the mesh for the final run. V4.1 is now really good for quite complex CFD, but I must state I do not have any comparison of "real complex CFD" as done with other tools -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content