Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Matching of geometry units and physics units
Posted 6 feb 2017, 10:38 GMT-5 Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization Version 4.4 1 Reply
Please login with a confirmed email address before reporting spam
Hello everyone,
(a) Is it necessary to match the units of geometry and physics model parameters? I am working with a 2-D coupled spatio-temporal population dynamics model in COMSOL version 4.4, where the unit of length is meter (m), and I am visualizing the output in the scale of milisecond (ms). The physics model parameters have the unit in meter and sec. Is it required to convert msec to sec while entering the physics parameters values?
Thanks in advance.
Jeet
(a) Is it necessary to match the units of geometry and physics model parameters? I am working with a 2-D coupled spatio-temporal population dynamics model in COMSOL version 4.4, where the unit of length is meter (m), and I am visualizing the output in the scale of milisecond (ms). The physics model parameters have the unit in meter and sec. Is it required to convert msec to sec while entering the physics parameters values?
Thanks in advance.
Jeet
1 Reply Last Post 6 feb 2017, 17:43 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
In COMSOL, you can enter each input with its own units by using square brackets: 5[m]+3[in]=507.62[cm].
COMSOL takes care of the conversions for you.
Best,
Jeff
COMSOL takes care of the conversions for you.
Best,
Jeff