Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modeling Induction Heating of a Pancake-Like Coil

Posted 13 feb 2017, 12:57 GMT-5 Low-Frequency Electromagnetics, Heat Transfer & Phase Change Version 5.2a 0 Replies

Maestro
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to model induction heating of a pancake-like coil embedded in a beam (both in 2D and 3D). I followed the COMSOL induction heating example (www.comsol.com/model/inductive-heating-of-copper-cylinder-148) when constructing the model. After running the analysis, there is no discernible temperature change and seemingly no induced current in the beam. Has anyone encountered a similar problem?
0 Replies Last Post 13 feb 2017, 12:57 GMT-5
COMSOL Moderator

Hello Maestro

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content