Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

modelling dichroic optical filter

Posted 5 lug 2017, 03:30 GMT-4 0 Replies

Craig Ingram
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello all, I am hoping there is a simple solution to this but I cannot work it out. I am trying to model two dichroic filters (dielectric filters) using the geometric optics interface. I have two lasers (release from grid) incident one the filter. One laser I want to transmit through the back surface and the other I want to reflect off the front surface so they are aligned (and then separated at the second filter).
I have created my geometry and applied a material discontinuity to the optics and selected 'single-layer coating' (Material Discontinuity>Coatings>thin dielectric films on boundary) and filled in the required parameters (n,R, lambda, matched with 'release from grid' and angle of incident for specified film properties.) But they both pass straight through. I have searched about and cannot find anything similar to this issue.

Also, I am wanting on of the lasers to have a 20mm beam diameter. Is there a simple way to do this using the release from grid command?

Thanks for any help.


I have tried attaching my model but cannot even get that to work...
0 Replies Last Post 5 lug 2017, 03:30 GMT-4
COMSOL Moderator

Hello Craig Ingram

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content