Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Why could't I mesh the geometry?
Posted 9 mar 2011, 16:42 GMT-5 Version 4.1 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I have tried a lot and read the help manual but still could not find solutions.
I have created the intersecting pipes model (inside) which was imported from Pro/E (we perchased the CAD Import module) and a block (ourside) which was created in Comsol.
I tried to mesh it but it did not work. The comsol alway pops out error: Internal geometry error!!
Do you have any advices? Thanks very much.
I have tried a lot and read the help manual but still could not find solutions.
I have created the intersecting pipes model (inside) which was imported from Pro/E (we perchased the CAD Import module) and a block (ourside) which was created in Comsol.
I tried to mesh it but it did not work. The comsol alway pops out error: Internal geometry error!!
Do you have any advices? Thanks very much.
1 Reply Last Post 10 mar 2011, 01:02 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
it all depends on the geometry, there are many help instructions in the KB as well on the forum + the examples in the doc. Meshing is an "art" an requires some experimenting
--
Good luck
Ivar
it all depends on the geometry, there are many help instructions in the KB as well on the forum + the examples in the doc. Meshing is an "art" an requires some experimenting
--
Good luck
Ivar