Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Measuring diameter of a contour

Posted 3 set 2017, 06:50 GMT-4 RF & Microwave Engineering, Heat Transfer & Phase Change Version 5.2a 0 Replies

Chathura Keerawella
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi ,

I am simulating tumour ablations and need to measure the diameter of the output contour(Iso-therm). I could not figure out a reliable method to do it. That would be great if someone in the community can assist me.

Thanks in Advanced.

CK
0 Replies Last Post 3 set 2017, 06:50 GMT-4
COMSOL Moderator

Hello Chathura Keerawella

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content