Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Electric current and Electric circuit

Posted 7 set 2017, 15:23 GMT-4 Version 5.0 0 Replies

Shamor
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am comparatively new at COMSOL. I am trying to simulate two part of my problem.

1) Two electrode for current carrying
2) Other each of four electrode attached with external resistor. Two of them will shorted. Other two will also shorted. I want to measure the potential between resultant two nodes.

The set up can be better understood from my schematic that i have attached.

I have used terminal 1 and ground feature for current carrying. And other four terminal for voltage measurement. I also have attached four terminal with external I vs U. But i cant find the solution. Shows error in performing the simulation.

Reason may be terminal are not connected with external I vs U. Or node connection.

Any help will be highly appreciated

Attachments:

0 Replies Last Post 7 set 2017, 15:23 GMT-4
COMSOL Moderator

Hello Shamor

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content