Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Model diffusion through contact interface
Posted 17 set 2017, 16:28 GMT-4 General, Battery Design, Geometry Version 5.2a 2 Replies
Please login with a confirmed email address before reporting spam
Dear all,
I want to simulate the mass diffusion inbetween two contact parts. First I assemble two parts with a contact pair. Then in the 'Transport of Diluted Species' module, how could I set the contact interface as a diffusion continuity interface instead of 'no flux'? There is an option in the 'Pair' -> 'Continuity'. However, once I select the contact pair, this pair automaticallt becomes the "No Flux" as a subnode.
Best, Rong
Please login with a confirmed email address before reporting spam
Not quite sure what is the reason as I havent used assembly to solve transport process. But I do believe when you right click on pair you will see fallback features allowing you to use continuous boundary condition.
-------------------Seeking collaborating partners for comsol consulting service
Please login with a confirmed email address before reporting spam
Not quite sure what is the reason as I havent used assembly to solve transport process. But I do believe when you right click on pair you will see fallback features allowing you to use continuous boundary condition.
Thank you for your reply, Yu.
Actually, there is a subnode named 'Continuity' in the 'pair'. But as I metioned, even I assign the contact interface as 'Continuity', the subnode under 'Continuity' is still 'no flux' which means this interface is still ynder discontinuous boundary condition. So confused...