Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Why can't I sweep my mesh?

Posted 31 mar 2011, 08:49 GMT-4 Battery Design, Geometry, Mesh 0 Replies

Nabil Kenan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I have designed a flow channel for the PEM fuel cell that diverges then converges.

I meshed the edges, used the "Mapped" function and then tried to use the sweep function but it doesn't work. I have attached the file. Could you please assist me?

I tried auto meshing by using the tetrahedral function, but the contours I got did not make sense so I guess the tetrahedral elements are not suitable for this case.

Regards
Nabil

Attachments:

0 Replies Last Post 31 mar 2011, 08:49 GMT-4
COMSOL Moderator

Hello Nabil Kenan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content