Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error: NaN or Inf found when solving linear system using SOR

Posted 26 feb 2018, 09:20 GMT-5 Wave Optics Version 5.2a 1 Reply

Jana Ladygina
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am trying to compute a plasmonic structure (3D model waveoptics) for a wavelength of 633 nm. However, every time when I run the simulation I got this error: "Undefined value found. - Detail: NaN or Inf found when solving linear system using SOR."

I applied/tried a finer meshing and physics controlled meshing as well but everytime the same error appears.

Could anyone help me to solve it?

1 Reply Last Post 6 lug 2018, 00:18 GMT-4
COMSOL Moderator

Hello Jana Ladygina

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Francois Swiadek
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 6 lug 2018, 00:18 GMT-4

Hi :

see : https://www.comsol.com/forum/thread/57051/nan-or-inf-found-when-solving-linear-system-using-sor-in-rf-module by Niels Chen : "This typically happens in models where the frequency is too high for the waves to be properly resolved by the mesh".

Though this is not the case in my model, hopefully it will be helpful for others who encounter the "NaN or Inf found when solving linear system using SOR" error.

Best,

François

Hi : see : https://www.comsol.com/forum/thread/57051/nan-or-inf-found-when-solving-linear-system-using-sor-in-rf-module by Niels Chen : "This typically happens in models where the frequency is too high for the waves to be properly resolved by the mesh". Though this is not the case in my model, hopefully it will be helpful for others who encounter the "NaN or Inf found when solving linear system using SOR" error. Best, François

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content