Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Densification using COMSOL
Posted 25 lug 2018, 02:20 GMT-4 RF & Microwave Engineering, Structural & Acoustics, Structural Mechanics 0 Replies
Please login with a confirmed email address before reporting spam
Hello!
I need help in changing the non-linear solid mechanics equation using the user-defined section. I checked other models in the non-linear node (e.g. Ramberg-Osgood, Power law, uni-axial data), but I found them not applicable.
σ=G(ε ̇ )+K tr((ε ̇ ))-1/3 G tr((ε ̇ ))i+Pli
where (ε ̇ ) is the strain rate tensor, i is the identity tensor, Pl is the sintering stress, ψ and φ are the bulk and shear moduli, respectively.
Any help is much appreciated.
Regards, Faris
Attachments:
Hello Faris Sweidan
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.