Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Conjugate Heat Transfer, Duct Boundary Conditions?

Posted 9 giu 2011, 15:09 GMT-4 Heat Transfer & Phase Change Version 3.5a 1 Reply

Matthew Williamson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have successfully modeled forced convection over a heat sink. I have a known inlet temperature and velocity. I have run into problems when I add a duct geometry about the heat sink and air. My first question is about the boundary conditions on the outside of the duct. At first, I used a fixed temperature equal to the ambient temperature. I believe that is causing a cooler solution than reality. My next attempt was to use surface-to-ambient radiation on the exterior of the duct with a know emissivity and ambient temperature.

I have not yet found an acceptable solution with this method. Does there need to be a know medium outside the duct to radiate to?

Thanks for your help
1 Reply Last Post 21 lug 2011, 08:11 GMT-4
COMSOL Moderator

Hello Matthew Williamson

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Yaseen Al Waaly
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 21 lug 2011, 08:11 GMT-4
Hi there,
You can convective flux as a boundary condition.
Hi there, You can convective flux as a boundary condition.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content