Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error: Failed to evaluate operator double Jacobian. - Operator: mean

Posted 28 giu 2011, 17:36 GMT-4 Fluid & Heat, Heat Transfer & Phase Change Version 3.5a, Version 4.2 2 Replies

Catherine Robin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I am new to 4.2, and fairly novice to Comsol in general. I am coupling laminar flow (spf) with heat transfer and the moving mesh (ALE), and I keep getting the error above, which I can't locate in any discussion or documentation. I get the same error whether I enable the moving mesh or not. I did not get this error in 3.5a.

Anyone else?

Thanks
Catherine
2 Replies Last Post 21 feb 2012, 08:07 GMT-5
COMSOL Moderator

Hello Catherine Robin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Diego Passarella
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 21 feb 2012, 07:27 GMT-5
Hello,

I'm having the same problem. I have an evolutionary model (chmm + 2*chcc) that runs in 3.5a and when I try to run it in 4.2 doesn't start because Time Dependent Solver 1 (Sol1/t1) cannot evaluate operator jacobian.

Any suggestions?
Hello, I'm having the same problem. I have an evolutionary model (chmm + 2*chcc) that runs in 3.5a and when I try to run it in 4.2 doesn't start because Time Dependent Solver 1 (Sol1/t1) cannot evaluate operator jacobian. Any suggestions?
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 21 feb 2012, 08:07 GMT-5
Hi

that probably means you have some Boolean or Dirac type BC defined so that COSOL cannot catch the derivatives of the variables w.r.t. a parameter sweep or the time variable

not easy to say more just like that

--
Good luck
Ivar
Hi that probably means you have some Boolean or Dirac type BC defined so that COSOL cannot catch the derivatives of the variables w.r.t. a parameter sweep or the time variable not easy to say more just like that -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content