Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing and Boundary conditions in U tube borehole heat exchanger

Posted 4 lug 2011, 07:29 GMT-4 Heat Transfer & Phase Change Version 4.0 0 Replies

Akshay Gupta
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hii, I am working on Comsol 4.0 on U-tube borehole heat exchanger with pipe length of 10 meters, diameter 10 cm and thickness 3 mm. I am able to do meshing of water inside the pipe but found problems in meshing of pipe. Meshing of pipe takes a lot of time and at end gives an error message-> ftet.

Please help me in doing meshing of the model.

Also, my goal is to find outlet temperature (time dependent) for a fixed inlet temperature (with ground temperature not fixed)for this underground heat exchanger, please help me choosing appropraite boundary conditions.

Thank you,

Akshay
0 Replies Last Post 4 lug 2011, 07:29 GMT-4
COMSOL Moderator

Hello Akshay Gupta

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content