Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
[comsol 3.5a]Extrusion coupling variables
Posted 9 dic 2009, 06:06 GMT-5 1 Reply
Please login with a confirmed email address before reporting spam
Hello
I have the same 3D geometry in two different geometry space, geom1 and geom2.
In geom1 I launch a radiation (heat transfer) analysis, with this analysis i find T distribution i particular on one surface.
Now I want to assign this T distribution obtained along one interesting boundary in the corrisponding boundary in geom2 to launch a conduction analysis.
I have tried to use Extrusion coupling variables with linear transformation (source and destination are the same surfaces only in different geom) and launch the 2 analysis at the same time but in conduction analysis I don't find the T distribution that i try to assign with extrusion variables.
Thank you in advance
Luca
I have the same 3D geometry in two different geometry space, geom1 and geom2.
In geom1 I launch a radiation (heat transfer) analysis, with this analysis i find T distribution i particular on one surface.
Now I want to assign this T distribution obtained along one interesting boundary in the corrisponding boundary in geom2 to launch a conduction analysis.
I have tried to use Extrusion coupling variables with linear transformation (source and destination are the same surfaces only in different geom) and launch the 2 analysis at the same time but in conduction analysis I don't find the T distribution that i try to assign with extrusion variables.
Thank you in advance
Luca
1 Reply Last Post 7 gen 2010, 14:58 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hello
I have the same 3D geometry in two different geometry space, geom1 and geom2.
In geom1 I launch a radiation (heat transfer) analysis, with this analysis i find T distribution i particular on one surface.
Now I want to assign this T distribution obtained along one interesting boundary in the corrisponding boundary in geom2 to launch a conduction analysis.
I have tried to use Extrusion coupling variables with linear transformation (source and destination are the same surfaces only in different geom) and launch the 2 analysis at the same time but in conduction analysis I don't find the T distribution that i try to assign with extrusion variables.
Thank you in advance
Luca
Hello Luca,
please check following thread:
www.comsol.com/community/forums/general/thread/994/
There is an excellent description of how to use coupling variables there, given by Ivar Kjelberg
God Luck
/janusz