Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

frequency domain analysis

Posted 26 set 2011, 04:23 GMT-4 Version 4.2 3 Replies

Anis Nurashikin Nordin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

HI everyone,

Currently I'm designing the clamp clamp beam resonator. I managed to fine eigenfrequencies but stuck in solving frequency domain analysis. Anyone can assist me to fix this issue?Attached is the simulation file(comsol 4.2)
The range of frequencies between 10MHz until 120 MHz.


Regards

Attachments:

3 Replies Last Post 27 set 2011, 02:43 GMT-4
Nagi Elabbasi Facebook Reality Labs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 26 set 2011, 17:51 GMT-4
You have no loads for the frequency domain analysis.
You have no loads for the frequency domain analysis.
Anis Nurashikin Nordin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 26 set 2011, 20:39 GMT-4
Hi

Thanks Nagi. I have loaded the number of frequency. Hereby , attached is the updated file (comsol 4.2).Can you check for me.

Regards
Hi Thanks Nagi. I have loaded the number of frequency. Hereby , attached is the updated file (comsol 4.2).Can you check for me. Regards

Attachments:

Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 27 set 2011, 02:43 GMT-4
Hi

here is the model back with a few changes, to allow you to see the different modes. Now you can ask yourself why you have these number of eigenmodes and why they show up on some and not on other graphs :)

for the eigenfrequency solver I'm using the Mass matrix normalisation, so you tables are given the relative mass w.r.t. the three displacements, unfortunately, COMSOL does not show the rotational relative inertias (yet, I still hoping or future improvements ;)

--
Good luck
Ivar
Hi here is the model back with a few changes, to allow you to see the different modes. Now you can ask yourself why you have these number of eigenmodes and why they show up on some and not on other graphs :) for the eigenfrequency solver I'm using the Mass matrix normalisation, so you tables are given the relative mass w.r.t. the three displacements, unfortunately, COMSOL does not show the rotational relative inertias (yet, I still hoping or future improvements ;) -- Good luck Ivar

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content