Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Differential (multielement) lumped ports in RF module

Posted 6 mag 2019, 12:13 GMT-4 Electromagnetics, RF & Microwave Engineering 0 Replies

Mauricio Yañez
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am using the differential (multielement Lumped ports) ports of the RF module to run an S-parameter analysis on a couple of differentiaol traces on a PCB.

Under Settings the reference characteristic impedance is set as Zref = 50 Ohm. Is that a differential or single-ended reference impedance?

I am doing a port and frequency sweep to save the S-parameters over frequency. Are saved S-parameters differential?

Thank You

0 Replies Last Post 6 mag 2019, 12:13 GMT-4
COMSOL Moderator

Hello Mauricio Yañez

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content