Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Some fluid disappear during the simulation on two phases flow model.
Posted 17 nov 2011, 20:50 GMT-5 Fluid & Heat Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
I'm working on the simulation of electrospinning.
My problem, the droplet from the nozzle going down so some fluid disappear. A part of my fluid going into the inlet which is normally impossible because my inlet is flow rate. You can see easily if you run my simulation.
If you have some subjection to fix this problem.
Max.
I'm working on the simulation of electrospinning.
My problem, the droplet from the nozzle going down so some fluid disappear. A part of my fluid going into the inlet which is normally impossible because my inlet is flow rate. You can see easily if you run my simulation.
If you have some subjection to fix this problem.
Max.
Attachments:
1 Reply Last Post 5 dic 2011, 20:01 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Maybe it's an over problem but my simulation still not working. I can't understand, I use exactly the same value from a paper (I attached). I can't found were I made a mistake so please can you help me. I'm really disappointed.
Max.
Max.
Attachments: