Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

To convert a parametric curve in a 3D object

Posted 6 set 2019, 04:55 GMT-4 Electromagnetics, Low-Frequency Electromagnetics 2 Replies

Antonio Sunseri
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everyone, I have to realize a toroidal coil so I have used a parametric curve but now I want to give a thickness to the coil. I tried with the sweep instrument but i don't have any face as input. How can I do that? Thanks to all

Attachments:

2 Replies Last Post 6 set 2019, 13:34 GMT-4
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 6 set 2019, 08:40 GMT-4

Antonio,

Attached is your toroidal coil.

Regards, Sergei

Antonio, Attached is your toroidal coil. Regards, Sergei
Antonio Sunseri
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 6 set 2019, 13:34 GMT-4

Sergei, thanks a lot for the help!

Sergei, thanks a lot for the help!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content