Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Charge Accumulation under Voltage (AC/DC)

Posted 9 feb 2020, 02:34 GMT-5 Low-Frequency Electromagnetics, MEMS & Nanotechnology, Ray Optics, RF & Microwave Engineering 0 Replies

Md Didarul Islam
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have been trying to figure out if there will be accumulated charge around nanoparticles on a thin-film, if the film is under AC or DC potential. There are hypothesis suggesting that charge carrier relaxation time difference between film material and nanoparticles can cause this charge accumulation.

I am relatively new to COMSOL, and have been trying out to see if this is possoible to model. Which modules should I use, and how to model this? Any advise would be highly appreciated.

I have attached the schematic drawing. Schematic

Attachments:

0 Replies Last Post 9 feb 2020, 02:34 GMT-5
COMSOL Moderator

Hello Md Didarul Islam

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content