Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
plotting only part of mesh in Comsol 4.x (like meshplot with ellog in Comsol 3.5a)
Posted 9 gen 2012, 08:12 GMT-5 Version 3.5a, Version 4.2a 2 Replies
Please login with a confirmed email address before reporting spam
Hi,
in Comsol 3.5a it was possible to plot only a part of a mesh by using meshplot and defining constraints with 'ellog'. Is there an equivalent feature included in Comsol 4.x for mphmesh or another way of getting this done?
Thank you in advance
in Comsol 3.5a it was possible to plot only a part of a mesh by using meshplot and defining constraints with 'ellog'. Is there an equivalent feature included in Comsol 4.x for mphmesh or another way of getting this done?
Thank you in advance
2 Replies Last Post 9 gen 2012, 09:47 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
In V4, try to add a Plot "Filter" (right click the plot sub-node) with "x>0" or some other Boolean expression.
Or make a sub-Data set via an appropriate cut plane, line ...
--
Good luck
Ivar
In V4, try to add a Plot "Filter" (right click the plot sub-node) with "x>0" or some other Boolean expression.
Or make a sub-Data set via an appropriate cut plane, line ...
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thank you Ivar - this works for me perfectly :)