Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Regarding a multiple heat flux boundary condition

Please login with a confirmed email address before reporting spam

I am using COMSOL with MATLAB Livelink on a cluster. Now in MATLAB I get say 10 Heat Flux values for 10 concentric rings on a surface which I need to pass on to COMSOL for further heat transfer analysis. But the COMSOL model has more meshes than 10 (total mesh points on the surface boundary are 1800+ - 'Normal' physics controlled mesh used). How can I specify heat flux for all those data points on the same surface for COMSOL? I need to basically interpolate the 10 heat fluxes into a lotmore according to the mesh on the boundary and those should be the heat flux input for the COMSOL model.


0 Replies Last Post 8 mag 2020, 10:06 GMT-4
COMSOL Moderator

Hello Arijit Upadhyay

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.