Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to use solved variables from Laminar / Turbulent and heat transfer domain into deformed geometry ?

Please login with a confirmed email address before reporting spam

I am trying to do as follows :

  1. Simulate a laminar / turbulent flow in a tube.
  2. Calculate the Reynold's number, ( at all cross section , ofcourse it will be same everywhere)
  3. Calculate variation of thickness based on the following formula :
  4. Implement , the reduction of thickness of tube with above formula using deformed geometry.

However, I am not able to calculate Reynold's number and use it in deformed geometry.

Can some one please tell me a sequence to do above ?

Deformed_geometry



0 Replies Last Post 10 set 2020, 11:00 GMT-4
COMSOL Moderator

Hello Parag Patil

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.