Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Transient analysis repeated error test failed

Please login with a confirmed email address before reporting spam

The original parameters of the material are used, and the transient analysis results normally. When a certain parameter of the material is modified and the solver uses the default settings, when the transient analysis is run again, the repeated error test fails, singularity may occur, and the last time step does not converge. . For this kind of error, how should I solve it.


0 Replies Last Post 19 set 2020, 07:30 GMT-4
COMSOL Moderator

Hello 浩堂 郄

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.