Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Lumped Port Magnetic Field Time Dependent Study
Posted 22 set 2020, 17:54 GMT-4 Low-Frequency Electromagnetics, MEMS & Nanotechnology, RF & Microwave Engineering 0 Replies
Please login with a confirmed email address before reporting spam
I have run into issues trying to perform a Magnetic Fields Time Dependent Study. When setting up a uniform lumped port I get the error "Uniform lumped port should be placed between two conductive boundaries". Trying instead the User Defined lumped port I get "Failed to find consistent intial values, Matrix has zero on diagonal, Last time step is not converged". I also have an initial frequency Domain step that should have passed the IV to the Time Dep.
I have seen posts stating a PEC or impedance BC is required for the lumped port to work but COMSOL does not allow this for time dependent studies. I have also attempted to run the model with both a stationary and frequency study and have got errors, maybe I have BC applied incorectly.
Attachments:
Hello Mitchell Glodowski
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.