Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

the problem about moving mesh method and free surface problem

Please login with a confirmed email address before reporting spam

Hi.I tried to simulate a thinnest bar(or a line) rotated in a rectangular box and .The left,right,and bottom of box are no slip condition.But the top of box are free surface.I want to observe the situation about free surface. I want slove it by using moving mesh methods.Also,I want the bar rotate by the circle center on (0,0) point and it is also the endpoint of the bar.There are lots of ways Iike "rotate boundary" or'otating domain",and I tried for long time but I can't understand how it work .! (the modle is like the the problem but the bar is rotating not move horizontallyhttps://www.comsol.com/blogs/modeling-free-surfaces-in-comsol-multiphysics-with-moving-mesh/)


0 Replies Last Post 18 ott 2020, 23:51 GMT-4
COMSOL Moderator

Hello Wang Zhi-Cheng

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.