Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
k-epsilon turbulent flow error when angle of attack is changed
Posted 10 apr 2012, 06:20 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD) Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
Hi
I am currently working on a project where I use Comsols k-epsilon to calculate lift/drag coeft fisients on sertain bladeprofiles for an underwater turbine.
I have imported a geometry and gotten good results for angles of attack of 0,4,8 and 12 degreese, but when I try for 16,20,24 degreese and so on I recive errors when I try to Compute.
Errormessage is most often:
"Undefined value found.
- Detail: NaN or Inf found when solving linear system using PARDISO."
But sometimes when I try computing again (not changing anything, just pressing "compute" again) I get a diffrent error message.
I have attached a screenshot of the error message.
The only thing I have changed is a rotation of the bladeprofile.
What can I do to get reults for these angles of attack?
Kind regards
Magnus Booe
I am currently working on a project where I use Comsols k-epsilon to calculate lift/drag coeft fisients on sertain bladeprofiles for an underwater turbine.
I have imported a geometry and gotten good results for angles of attack of 0,4,8 and 12 degreese, but when I try for 16,20,24 degreese and so on I recive errors when I try to Compute.
Errormessage is most often:
"Undefined value found.
- Detail: NaN or Inf found when solving linear system using PARDISO."
But sometimes when I try computing again (not changing anything, just pressing "compute" again) I get a diffrent error message.
I have attached a screenshot of the error message.
The only thing I have changed is a rotation of the bladeprofile.
What can I do to get reults for these angles of attack?
Kind regards
Magnus Booe
Attachments:
1 Reply Last Post 26 apr 2012, 16:31 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
same problem here, especially at large positional angles when analyzing blades of a turbine.