Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Identity pair as light source in Comsol 4.2
Posted 14 mag 2012, 10:45 GMT-4 RF & Microwave Engineering 0 Replies
Please login with a confirmed email address before reporting spam
I have simulated a model, please see attached.
If I do “form the union”, the inner boundary can not be used to set as SBC or Port.
So I do "form a assembly", and define a idensity pair. Now I can set the inner boundary as light source.
However, an error occurs as:
Automatic scaled regions cannot treat selections without exterior and interior boundaries.
PML geometric setting types is Cartesian, I change PML geometric setting types as General,
The calculation can process, but the results are confusing.
Expecting you to give me some help!
Million thanks!
Attachments:
Hello Marvin Farrell
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.