Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to extrude an imported 2D .dxf file in COMSOL

Posted 5 mag 2021, 17:07 GMT-4 Electromagnetics, Microfluidics, Geometry Version 5.6 2 Replies

Koorosh Esteki
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello Everyone,

I have a generated 2d image which is converted to dxf file. It can be easily imported and recognizied all the edges and points. But I like to convert to 3d by extruding it. Is there any way to convert it to cylindrical cross section and rectangular cross section. I have attached the model. Any help please? Thank you!

Attachments:

2 Replies Last Post 6 mag 2021, 13:02 GMT-4
Robert Koslover Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 5 mag 2021, 22:19 GMT-4

You've imported your 2D file into your 3D geometry. It is apparently a set of lines, without surfaces. And it is not actually "in" the workplane you then created afterward. I suggest you instead import your 2D file directly into the workplane of interest (the software will let you do that; try it.) You also need to form surfaces to extrude, or else you will extrude a frame, not a volume. I suggest you try that and see if you can figure out the rest. If not, see how far you can get and repost your model.

-------------------
Scientific Applications & Research Associates (SARA) Inc.
www.comsol.com/partners-consultants/certified-consultants/sara
You've imported your 2D file into your 3D geometry. It is apparently a set of lines, without surfaces. And it is not actually "in" the workplane you then created afterward. I suggest you instead import your 2D file directly into the workplane of interest (the software will let you do that; try it.) You also need to form surfaces to extrude, or else you will extrude a frame, not a volume. I suggest you try that and see if you can figure out the rest. If not, see how far you can get and repost your model.
Koorosh Esteki
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 6 mag 2021, 13:02 GMT-4

Thank you for your reply. You are correct it has to be 2d surface inorder to extrude which I ignored. I fix this issue by using SolidWorks CAD design.

Thank you for your reply. You are correct it has to be 2d surface inorder to extrude which I ignored. I fix this issue by using SolidWorks CAD design.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content