Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

mass and heat transfer simulation between water and vapor

Posted 21 set 2021, 08:07 GMT-4 Computational Fluid Dynamics (CFD), Heat Transfer, Equation-Based Modeling 1 Reply

Wen Wen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I want to simulate heat and mass transfer between water and vapor in the heat pipe,but I'm not sure which Physics model I should use in Comsol, especially for mass transfer, should I build equation myself?

Thank you very much if you have experience like this. best regards

1 Reply Last Post 29 set 2021, 14:04 GMT-4
Leland Macintosh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 29 set 2021, 14:04 GMT-4
Updated: 3 years ago 29 set 2021, 14:20 GMT-4

Hi Wen, If you know the physics-based equations, I suggest you try the coefficient form PDE in COMSOL. There, you can define any arbitrary geometries and any forms of PDEs to solve.

Regards

Hi Wen, If you know the physics-based equations, I suggest you try the coefficient form PDE in COMSOL. There, you can define any arbitrary geometries and any forms of PDEs to solve. Regards

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content