Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
PCB layer mesh problem
Posted 22 giu 2012, 16:16 GMT-4 Version 4.3 1 Reply
Please login with a confirmed email address before reporting spam
How can I make the square influenced by the heat source?
You and find that the mesh densities of the square and the bottom layer are different. I know that if I make the square and the bottom layer as an union, it will work. But I am wondering if I can only make it as two layer, what should I do then?
I have a two layers PCB. but the top layer seems independent to the bottom.There is a thermal Isolation around the square. How can I change it?
You and find that the mesh densities of the square and the bottom layer are different. I know that if I make the square and the bottom layer as an union, it will work. But I am wondering if I can only make it as two layer, what should I do then?
I have a two layers PCB. but the top layer seems independent to the bottom.There is a thermal Isolation around the square. How can I change it?
Attachments:
1 Reply Last Post 22 giu 2012, 17:09 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I believe you cannot do it that way, a 2D model has a default 1m depth in Z but you cannot define Z layers in 2D, for that you need to go 3D, by first extruding your imported 2D geometry.
In 3D you do not need to use assembly mode, use geometry union mode, you will then split the surface of your 3D and on this surface cut you can define a thin layer of a conductor (use material BOUNDARY and not Domain type, you might need to add a second material for the boundary definitions, that I haven't had time to check in 4.3 yet ;)
--
Good luck
Ivar
I believe you cannot do it that way, a 2D model has a default 1m depth in Z but you cannot define Z layers in 2D, for that you need to go 3D, by first extruding your imported 2D geometry.
In 3D you do not need to use assembly mode, use geometry union mode, you will then split the surface of your 3D and on this surface cut you can define a thin layer of a conductor (use material BOUNDARY and not Domain type, you might need to add a second material for the boundary definitions, that I haven't had time to check in 4.3 yet ;)
--
Good luck
Ivar