Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Convergence problem

Please login with a confirmed email address before reporting spam

Hello,

I am trying to simulate the water-air bubble (turbulence) flow. My model works fine for certain velocity (lower velocity) however, when I try running the simulation with higher velocity I get the convergence issue. Can anyone suggest me what could me the issue?


2 Replies Last Post 30 nov 2021, 14:00 GMT-5
Amin Kazemi Postdoctoral Researcher, University of Toronto

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 30 ott 2021, 11:46 GMT-4

You have not provided enough detail of your model. However, one way to tackle this problem is to use the solution of the lower velocities as the initial condition for the higher velocities.

You have not provided enough detail of your model. However, one way to tackle this problem is to use the solution of the lower velocities as the initial condition for the higher velocities.

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 30 nov 2021, 14:00 GMT-5

Hello Amin, I was using bubbly flow but I think this model only works when the volume fraction of the dispersed phase is low. Use of mixture model solved the issue.

Hello Amin, I was using bubbly flow but I think this model only works when the volume fraction of the dispersed phase is low. Use of mixture model solved the issue.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.