Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

mems

Posted 3 lug 2012, 04:44 GMT-4 Version 4.0a 1 Reply

Eba Flora
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm doing thickness otimization using moving mesh.i'm able to change the length but i get same displacement for every thicknesss.did i need to do remeshing to mesh the new one if so how can i do remeshing
1 Reply Last Post 3 lug 2012, 08:57 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 3 lug 2012, 08:57 GMT-4
Hi

that depends how you set up your model, but are you sure you need ALE ?
If your geometry is simple use a Parameter for the critical thickness, and ADD a parametric sweep node above your first solver step and adjust the parameter there then solve.

Do not use a continuation sweep as that will not perfrom any "remesh" nor Geometry update

--
Good luck
Ivar
Hi that depends how you set up your model, but are you sure you need ALE ? If your geometry is simple use a Parameter for the critical thickness, and ADD a parametric sweep node above your first solver step and adjust the parameter there then solve. Do not use a continuation sweep as that will not perfrom any "remesh" nor Geometry update -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content