Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Contact Pair

Please login with a confirmed email address before reporting spam

Good evening, I would like to have some advice on how to set the conditions of Contact Pair for my problem: it is a model of pelvis prosthesis brought by cad to comsol; the model is divided into three parts and at the interface level I tried to set the constraint called contact pairs, following the tutorial, but it fails to converge and I get an error: "A solution could not be found. No convergence, relative step value too small. The reported solution has not reached convergence. Not all parameter values were returned. " I hope to receive an answer, thank you.



0 Replies Last Post 23 nov 2021, 15:07 GMT-5
COMSOL Moderator

Hello Ginevra Betti

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.