Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Varying Parameter for Cut Line 3D
Posted 5 lug 2012, 12:51 GMT-4 Low-Frequency Electromagnetics, Results & Visualization Version 4.3 4 Replies
Please login with a confirmed email address before reporting spam
I have a 3D model and I'd like to look at the electrical potential along a particular line within a certainly range. Specifically, I want to plot the potential along multiple cut lines within a cylinder of 1mm radius.
Instead of manually change the x & y coordinates of the Cut Line 3D, I'm wondering whether there exist a function like parameter sweep, which allows me to set up a variable and define its range. (e.g. x from 16 to 17, with step size of 0.1)
Thank you in advance.
Please login with a confirmed email address before reporting spam
you have the additional lines (sub tab of cut line) for that
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
This is only in 2D. :-(
Ralf
Please login with a confirmed email address before reporting spam
good remark, hadnt noticed the 3D issue, tested it rapidly again in 2D 4.3 htere it was OK.
I believe it's worth you send a suggestion for" improvement" to "support", it shouldnt be that difficult to implement
One thng to try, I'm jumping onm aplane in 2 minutes cannot try it myself, is to define a cut surface in 3D and then a cut line on the cut-surface, perhaps it works.
Pls report back in any case
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
I used a cut plane combined with a series of cut line 2D and it works well.
Thank you very much!