Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
thermal strain issue
Posted 16 lug 2012, 16:13 GMT-4 Structural Mechanics Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
Dear Sir,
I've an urgent question about thermal strain simulation. Comsol simulates the thermal strain for two contact plates separately. I was wondering how to make the strain distribution continuous.
Please see the attached file and give me some suggestions. I'd really appreciate your help.
Regards,
Elva
I've an urgent question about thermal strain simulation. Comsol simulates the thermal strain for two contact plates separately. I was wondering how to make the strain distribution continuous.
Please see the attached file and give me some suggestions. I'd really appreciate your help.
Regards,
Elva
Attachments:
1 Reply Last Post 17 lug 2012, 02:17 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
indeed you open an interesting question there ;)
You can also take a look at the Model Library - Structral - Thermal Structure Interactions - Layered Plate
If you add a boundary mesh layer on the internal interfaces you will also get steeper steps of the stress and strain
Question: are the steps in stress and strain physical or not ?
or should the strain be "smooth" across the boundaries ?
My first reaction is COMSOL is correct, but it doesn feel very intuitive and need some more thinking
Perhaps you get more convinced if you run a TS physics study on your model and increase the temperature gradually
--
Good luck
Ivar
indeed you open an interesting question there ;)
You can also take a look at the Model Library - Structral - Thermal Structure Interactions - Layered Plate
If you add a boundary mesh layer on the internal interfaces you will also get steeper steps of the stress and strain
Question: are the steps in stress and strain physical or not ?
or should the strain be "smooth" across the boundaries ?
My first reaction is COMSOL is correct, but it doesn feel very intuitive and need some more thinking
Perhaps you get more convinced if you run a TS physics study on your model and increase the temperature gradually
--
Good luck
Ivar