Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Obtain two simulations, RF Module, 4.2a

Posted 7 ago 2012, 22:09 GMT-4 RF & Microwave Engineering Version 4.2a 2 Replies

Nikola Bralovic
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All,

If I do some simulations from for wavelengths from 400nm to 1300nm, and after that from 1300nm to 2500nm, is there possible to obtain these two results in one?

Thanks in advanced.

2 Replies Last Post 8 ago 2012, 05:33 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 8 ago 2012, 01:17 GMT-4
Hi

if you try a frequency domain with a combined range of the type {range(400,100,1300) range(1350,50,2500)}*1E-9

it should work, but you can change at will the stepping, or even use only 1 range() operator. The only thing, the sequence should be STRICTLY monotonous (increasing or decreasing, and not repeating (this is no longer so in 4.3 if I have read the RN correct)

--
Good luck
Ivar
Hi if you try a frequency domain with a combined range of the type {range(400,100,1300) range(1350,50,2500)}*1E-9 it should work, but you can change at will the stepping, or even use only 1 range() operator. The only thing, the sequence should be STRICTLY monotonous (increasing or decreasing, and not repeating (this is no longer so in 4.3 if I have read the RN correct) -- Good luck Ivar
Nikola Bralovic
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 8 ago 2012, 05:33 GMT-4
Hello Ivar,

Thank you very much on your help.

Regards,

Nikola
Hello Ivar, Thank you very much on your help. Regards, Nikola

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content