Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
fail to couple laminar flow and transport of diluted species
Posted 18 set 2012, 11:10 GMT-4 Fluid & Heat 0 Replies
Please login with a confirmed email address before reporting spam
i am trying to couple laminar flow and transport of diluted species. it is a time-dependent simulation. the sink of 2 species is the bring part of an image. under stationary case, the coupling of the two modules works fine. when switching to time dependent simulation, the model can run and there is no error message. Flow can be simulated nicely. however no sign of species transport can be seen. the model is attached here. Hope someone can help a little bit.
Thanks in advance!!
Chunyan
Attachments:
Hello Chunyan Li
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.