Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary Conditions Changing When Exported to Matlab

Posted 25 set 2012, 18:52 GMT-4 Geometry, Mesh, Studies & Solvers, Structural Mechanics Version 4.3 0 Replies

J. Mendoza
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello Everyone,

I am using the 3D Structural Mechanics Beam Solver with a eigenfrequency study. In the comsol study I have it set to the standard free-free end conditions.
I use the codes below to extract the Mass (E) and Stiffness(K) matrices of the system with the live-link to matlab.
MA=mphmatrix(model,'sol1','out',{'K','D','E','L'});

K=MA.K;
D=MA.D;
E=MA.E;
L=MA.L;

I use matlab's eig to extract the eigen values and eigenvectors from the system. When I plot the mode shapes (extracted from the eigenvectors) the modes aren't consistent with free-free boundary conditions, they are consistent with sliding-sliding boundary conditions.

Is this a matlab problem or a comsol problem? Is there a way to fix it?

Thanks,

Joshua
0 Replies Last Post 25 set 2012, 18:52 GMT-4
COMSOL Moderator

Hello J. Mendoza

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content