Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Navier Slip Boundary condition

Please login with a confirmed email address before reporting spam

For laminar single phase flow through microchannel, When I put inlet and outlet condition: fully developed and wall as: No slip, I get fully developed profile from the very entrance of the channel. However when I Change the wall condition to Navier slip [20nm] while keeping both the inlet and outlet condition same, I dont get the fully developed profile from the very inlet.

Could anyone please explain the issue?



1 Reply Last Post 10 lug 2023, 15:50 GMT-4
Jim Freels mechanical side of nuclear engineering, multiphysics analysis, COMSOL specialist

Please login with a confirmed email address before reporting spam

Posted: 1 year ago 10 lug 2023, 15:50 GMT-4

Certainly. A no-slip wall specifies a zero velocity at the wall as a constraint; whereas a slip wall will not. As such, the slip wall has no constraint in the wall-normal direction except the zero gradient which is present as a "natural" condition of the weak form used by the finite-element method.

-------------------
James D. Freels, Ph.D., P.E.
Certainly. A no-slip wall specifies a zero velocity at the wall as a constraint; whereas a slip wall will not. As such, the slip wall has no constraint in the wall-normal direction except the zero gradient which is present as a "natural" condition of the weak form used by the finite-element method.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.