Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Model post processing results not stable for repeated model runs of simple model

Posted 20 feb 2010, 12:36 GMT-5 2 Replies

Allan Haas
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi Folks,

I have a model that uses point current sources to emulate a dipole using the Conductive Media DC physics package. I have tried a variety of meshes and have not come up with a situation that produces a stable post processing output. I am using points on the surface of the model as voltage measurements and a single positive and negative point current sources. What am I doing wrong in the model to cause it to not produce the same result run after run of the model?

I have attached my very simple model that has this problem.

Thanks,

Allan

Attachments:

2 Replies Last Post 7 giu 2013, 10:03 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 feb 2010, 15:33 GMT-5
Hi

Something I do not understand ! Arn't you doing ElectroStatics and should you use rather the (es) module ?

For me the dc is really for "running" currents, and with your point "sources" you problem is rather "static".

By the way, you have several nice models, among other on the faraday cage examples, in the Model Exchange

Hope this helps
Good luck
Ivar
Hi Something I do not understand ! Arn't you doing ElectroStatics and should you use rather the (es) module ? For me the dc is really for "running" currents, and with your point "sources" you problem is rather "static". By the way, you have several nice models, among other on the faraday cage examples, in the Model Exchange Hope this helps Good luck Ivar
Aman Kaur
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 7 giu 2013, 10:03 GMT-4
Dear Ivan,

I was looking for Faraday cage models but could not find any in the model exchange. Can you suggest where I can get these?

Thanks
Dear Ivan, I was looking for Faraday cage models but could not find any in the model exchange. Can you suggest where I can get these? Thanks

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content