Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Why we need 6000 Volatge for microgripper

Posted 8 dic 2012, 08:52 GMT-5 Version 4.3 1 Reply

Gagandeep Singh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

In the microgripper model given at comsol website at link

www.comsol.co.in/showroom/downloadfile/model/4695/version/comsol43a/file/models.mems.microgripper.pdf

It is written to apply a volatge of 6000 Volt.(written on page 2 of the paper)
My question is why we need such a high voltage for this model.
The actulal microgripper available in the market operate at 5 v only.

Please try to repond asap.

Thanks...
1 Reply Last Post 9 dic 2012, 05:56 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 9 dic 2012, 05:56 GMT-5
Hi

good remark, a true MEMS I doubt would use an X thousand volt actuator, up to 50[V] OK but hardly more. Perhaps the model is a bit crude, compared to todays technology

--
Good luck
Ivar
Hi good remark, a true MEMS I doubt would use an X thousand volt actuator, up to 50[V] OK but hardly more. Perhaps the model is a bit crude, compared to todays technology -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content